Canadian Salon Company
Electrical Installation – operating the Electric to the Cabinet Print
This guide that is instructional help with the planning/installation for the Electrical Power provide for the Acrylic Spas.
Most of our acrylic tubs have actually detachable cabinet panels which cover the perimeter that is entire of bath tub.
Whenever operating the electric through the spa, the access point in to the case doesn’t need become put right in the Control Pack location. Our spas try not to come loaded with a pre-drilled opening for electric so access could be through some of the case panels.*
*NOTE: We usually do not advise setting up the electric via a case panel this is certainly situated in front side a Pump, Control Pack, Blower, or Gate Valve. These panels will probably must be removed at some time for upkeep or servicing.
Choosing a spot
When selecting where you can enter the cabinet, do this in line with the after:
- security (don’t create hazards that are tripping
- access points for users to go into the bath tub
- action positioning
- cover opening position (bottom mount lifters may have the address remainder low near the case)
- cover lifter mounts
A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The perfect location to place a gap for the power cord, could be less than six ins up from the base associated with case panel, and four to six ins in through the outside side of the cabinet panel. Please be aware that the cabinet panels have lumber insulating and framework foam inserts. You will need to avoid drilling through the lumber framework as this may damage the support that is structural lumber provides.
We usually do not suggest coming through the beds base for the spa. If this is the absolute most perfect path then we suggest you are taking under consideration you will not be in a position to slide the bathtub at all.
This could pose issue if a site specialist is needed to access a region of the bath bath tub that is against an obstruction such as for example a wall surface or deck.
The Control Pack (where in actuality the electric will undoubtedly be linked) is situated behind one of many case panels straight below your Topside Control Panel (precise location will differ based on spa model).
There clearly was space that is enough the case to operate the energy cable through the access point out the Control Pack once we try not to totally fill the cavity with spray foam. The ability cord will have to enter the Control Pack through the left hand part.
To learn more about connecting the electrical to your circuit breaker, please click on our solution “Electrical Installation – Correct Wiring for a 240V Supply“.
In the event that you need any further help, be sure to contact client provider.