Electrical Installation – operating the Electric to the Cabinet Print
This guide that is instructional help with the planning/installation for the Electrical Power provide for the Acrylic Spas.
Most of our acrylic tubs have actually detachable cabinet panels which cover the perimeter that is entire of bath tub.
Whenever operating the electric through the spa, the access point in to the case doesn’t need become put right in the Control Pack location. Our spas try not to come loaded with a pre-drilled opening for electric so access could be through some of the case panels.*
*NOTE: We usually do not advise setting up the electric via a case panel this is certainly situated in front side a Pump, Control Pack, Blower, or Gate Valve. These panels will probably must be removed at some time for upkeep or servicing.
Choosing a spot
When selecting where you can enter the cabinet, do this in line with the after:
- security (don’t create hazards that are tripping
- access points for users to go into the bath tub
- action positioning
- cover opening position (bottom mount lifters may have the address remainder low near the case)
- cover lifter mounts
A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The perfect location to place a gap for the power cord, could be less than six ins up from the base associated with case panel, and four to six ins in through the outside side of the cabinet panel.